Software User Manual D-Link Unified Access System
02/15/2011
Document 34CS3000-SWUM104-D10 Page 39
Section 4: Installing the Hardware
This chapter provides instructions for installing the D-Link DWS-3024, DWS-3024L, and DWS-3026 switch hardware. The
following sections describe this installation process:
• “Hardware Overview”
- “Front Panel Components”
- “LED Indicators”
- “Rear Panel Description”
- “Side Panels”
• “Installation”
- “Package Contents”
- “Installation Guidelines”
- “Installing the Switch without the Rack”
- “Installing the Switch in a Rack”
- “Powering On the Switch”
- “Installing the SFP ports”
- “Installing the Optional Modules”
- “Connecting to the External Redundant Power System”
• “Connecting the Switch”
- “Connecting the Switch to the Network”
- “Connecting the Switch and AP Directly”
- “Connecting the Switch and AP through the L2/L3 Network”
- “Connecting to the Core Network”
HARDWARE OVERVIEW
This section describes the font, back, and side panels and the LED indicators on the switch. The DWS-3024/DWS-3024L
and DWS-3026 have slightly different front and back panels based on the available features.
Front Panel Components
The front panel of the Switch consists of LED indicators for Power, Console, RPS, PoE, and Link/Act/Speed for each port
on the Switch including 10GE Ports for optional modules and SFP port LEDs. <Link>Table 3 describes the LED indicators
in more detail.
To Next Page
Loading...
