D-Link Unified Access System Software User Manual
02/15/2011
Page 152 Document 34CS3000-SWUM104-D10
• If you select the check box and click Allow MAC, the MAC address is added to the Allow MAC List in the AP Profile
MAC Authentication settings.
• Click Refresh to update the screen with the most current information.
Each AP profile has one global MAC authentication list which is either a list to deny access to all MAC addresses on the list
or to allow access to all MAC addresses on the list. To se the mode for the default AP Profile, click the Administration >
Basic Setup > AAA/RADIUS tab. Set the MAC Authentication Default Action field to Allow or Deny all MAC Addresses in
the list. To set the mode for a different AP profile go to the Global tab on the AP Profile to configure.
The switch does not remove MAC entries from this list even when a client successfully authenticates with an AP. The
historical ad hoc data gives you more time to take action against clients that establish ad hoc networks on the WLAN.
Note: The MAC address is added to the local MAC authentication list for all profiles where the global default action
is set to allow (for Allow MAC), or deny (for Deny MAC). If you use RADIUS for MAC authentication in one or more
AP profiles, you must add the MAC to the RADIUS database.
Table 57: Ad Hoc Client Status
Field Description
MAC Address The Ethernet address of the client. If the Detection Mode is Beacon then the client is
represented as an AP in the RF Scan database and the Neighbor AP List. If the Detection
Mode is Data Frame then the client information is in the Neighbor Client List.
AP MAC Address The base Ethernet MAC Address of the managed AP which detected the client.
Location The configured descriptive location for the managed AP.
Radio The radio interface and its configured mode that detected the ad hoc device.
Detection Mode The mechanism of detecting this Ad Hoc device. The possible values are Beacon Frame or
Data Frame.
Age Time in seconds since last detection of the ad hoc network.
To Next Page
Loading...
Need help?
General
