Software User Manual D-Link Unified Access System
02/15/2011
Document 34CS3000-SWUM104-D10 Page 31
- Key caching
- Tunneled and distributed forwarding
- Peer-to-peer WLAN switch roaming
• Intrusion Detection
- Rogue AP detection
- Rogue Client detection
- Station blacklisting
- Ad-hoc network detection
• Network Management
- SNMP v1, v2c, v3
-CLI
- SYSLOG
- Up to 24 APs (DWS-3024L) or 48 APs (DWS-3024 and DWS-3026) per switch
- Auto AP image download
- D-Link WLAN Private MIB
• Simultaneous AP upgrade
• Centralized data forwarding via tunneling for fast roaming and unified QoS
• AP RF Monitoring
• Configuration & Firmware Upload/Download
Each AP supports up to 16 virtual access points (VAPs) per radio for DWL-8600. You can configure a unique SSID and
security policy on each VAP. The following list shows some of the D-Link Access Point features and standards support:
• WLAN and IEEE Standards
- IEEE 802.11a
- IEEE 802.11b
- IEEE 802.11d
- IEEE 802.11e (WMM)
- IEEE 802.11g
- IEEE 802.11h
- IEEE 802.11i (WPA2)
- IEEE 802.1X - 2001 Port Based Network Access Control
- IEEE802.3af PoE Support
• WLAN RF Features
-RF Scan
- Transmit Power Control
- Load Balancing
- Dynamic Channel Assignment
- Dual Radio Support
- Atheros Dynamic Turbo 5Ghz
- Atheros Dynamic Turbo 2.4 Ghz
- TELEC 4.9GHZ 802.11a modes
Note: For the IEEE 802.11e, only Unscheduled Automatic Power Save Delivery (U-APSD), part of the 802.11e,
is supported when DWL-8600APs are managed by a DWS-3000 switch.
To Next Page
Loading...
