46D-Link DWM-312 User Manual
Section 4 - Conguration
Select whether to Enable or Disable local SNMP administration.
Select whether to Enable or Disable remote SNMP administration.
Enter the password public in this eld to allow read-only access
to network administration using SNMP. You can view the network,
but no conguration is possible with this setting.
Enter the password private in this eld to enable read/write
access to the network using SNMP.
Enter up to 4 IP addresses to use as trap targets for your network.
Select the SNMP version of your system.
If you want to limit remote access SNMP access, enter the IP
address of the remote computer you will use to access this device;
all other IP addresses will be denied remote SNMP access.
Enter a contact point for the system for reference.
Enter the system name for reference.
Enter the system location for reference.
User Privacy Denition
User accounts can be dened for SNMP remote access. Click Edit
to change settings. Up to ve users can be added.
SNMP Local:
SNMP Remote:
Get Community:
Set Community:
IP 1/IP 2/IP 3/IP 4:
SNMP Version:
WAN Access IP
Address:
System Contact:
System Name:
System Location:
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each network
device to the administrator of the network. SNMP can be used to monitor trac and statistics of the DWM-312. The DWM-312 supports SNMP v1,
v2c, and v3. D-View software uses the SNMP protocol. For details on managing your device with D-View, see the D-View Manual.
SNMP
To Next Page
Loading...
Need help?
General
Weight and Dimensions
