D-Link GO-RT-N300 User Manual

22D-Link GO-RT-N300 User Manual
Section 3 - Conguration
Select Static IP from the drop-down menu.
Enter the static IP address which was provided to you by your
Internet Service Provider (ISP).
Enter the subnet provided by your ISP.
Enter the default gateway provided by your ISP.
Enter the Maximum Transmission Unit size. The default value
is 1500.
Enter the primary DNS server address provided by your ISP.
Enter the secondary DNS server address provided by your ISP.
Select the MAC address to be used for the connection. Select Default MAC to use
the router’s MAC address. Select MAC from PC to copy your PC’s MAC address,
or select MAC Manual to manually enter a MAC address in the field provided.
Click Apply Changes to save the current configuration, or click Reset to discard.
WAN Access
Type:
IP Address:
Subnet Mask:
Default
Gateway:
MTU Size:
DNS Server 1:
DNS Server 2:
MAC Clone:
If you choose Static IP, please configure the following fields;

D-Link GO-RT-N300 Specifications

Wireless Signal Rates

IEEE 802.11n 20MHz channel	150 Mbps (max)
IEEE 802.11n 40MHz channel	300 Mbps (max)
IEEE 802.11g rates	54 Mbps - 48 Mbps - 36 Mbps - 24 Mbps - 18 Mbps - 12 Mbps - 11 Mbps - 9 Mbps - 6 Mbps

Operating Environment

operating temperature	0 °C to 40 °C (32 °F to 104 °F)
storage temperature	-20 °C to 65 °C (-4 °F to 149 °F)
humidity	10% minimum to 95% maximum (non-condensing)

Dimensions

length	160 mm (6.3 inches)
width	120 mm (4.72 inches)
height	59 mm (2.32 inches)