MPPERC4128
Use an RC4 128 bit MPPE session key with MS-CHAP or
MS-CHAP v2 authentication protocol. (Default: Yes)
DialOnDemand
Enable Dial-on-demand which means that the L2TP/PPTP
tunnel will not be setup until traffic is sent on the interface.
(Default: No)
ActivitySensing
Specifies if the dial-on-demand should trigger on inbound or
outbound traffic or both. (Default: BiDirectional)
IdleTimeout
Idle timeout in seconds for dial-on-demand. (Default: 3600)
Metric
Specifies the metric for the auto-created route. (Default: 90)
MTU
Specifies the size (in bytes) of the largest packet that can be
passed onward. (Default: 1456)
AutoInterfaceNetworkRoute
Automatically add a route for this interface using the given
remote network. (Default: Yes)
MPPEAllowStateful
Allow usage of Stateful MPPE (less secure, use only for com-
patibility). (Default: No)
MemberOfRoutingTable
All or Specific. (Default: All)
RoutingTable
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Comments
Text describing the current object. (Optional)
3.30.7. L2TPServer
Description
A PPTP/L2TP server interface terminates PPP (Point to Point Protocol) tunnels set up over existing
IP networks.
Properties
Name
Specifies a symbolic name for the interface. (Identifier)
IP
The IP address of the PPTP/L2TP server interface.
TunnelProtocol
Specifies if PPTP or L2TP should be used for this tunnel.
(Default: PPTP)
Interface
The interface that the PPTP/L2TP Server should be listening on.
ServerIP
Specifies the IP that the PPTP/L2TP server should listen on, this
can be an IP of a interface, or for example an ARP published IP.
UseUserAuth
Enable the use of user authentication rules on this server.
(Default: Yes)
MPPENone
Allow no authentication for this tunnel. (Default: Yes)
MPPERC440
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
3.30.7. L2TPServer Chapter 3. Configuration Reference
140
To Next Page
Loading...
