Run burn-in tests for a set of sub tests. If no sub tests are specified the following are included: -
memory, -ping, -traffic, -cryptoaccel.
selftest -abort
Abort a running self test.
selftest
Show the status of a running test.
Options
-abort
Abort a running self test.
-burnin
Run burn-in tests for a selected set of sub tests.
-cryptoaccel
Verify the correct functioning of available crypto accelerator
cards.
-hours[=<Integer>]
Test duration in hours. (Default: 48)
-interfaces=<Interface>
Ethernet interface(s).
-mac
Check if there are MAC address collisions on the interfaces.
-media
Check the sanity of the disk drive.
-memory
Check the sanity of the RAM.
-minutes[=<Integer>]
Test duration in minutes. (Default: 0)
-num=<Integer>
Number of times to execute the test. (Default: 1)
-ping
Run a ping test over the interfaces.
-size=<Integer>
Size of media space to utilize in the test. Set in MB. (Default:
1)
-throughput
Run a throughput test over the interfaces. This will show the
maximal achievable interface throughput.
-traffic
Run a traffic test over the interfaces. The traffic test uses
mixed frame sizes and verifies the content of each received
frame.
Note
Requires Administrator privilege.
2.2.60. services
Show runtime values of configured services.
Description
Shows the runtime values of all configured services.
2.2.60. services Chapter 2. Command Reference
67
To Next Page
Loading...
