Daedong HX9010 - Stopping the Engine

5
OPERATION
5
-
7
STOPPING THE ENGINE
1. Make sure to reduce the engine rpm
before stopping the engine.
2. Depress the clutch pedal and put all
shift levers in the neutral position.
3. Run the engine at the idle speed for
approx. 2 to 3 minutes, and then turn
the key switch to the "OFF" position
to stop the engine.
T85O532A
IMPORTANT
• Turn o󰀨 all the electrical devic-
es and remove the ignition key
before leaving the tractor.
• Do not leave the tractor outside
unattended. It can be stolen
as the key used for all KIOTI
tractors are the same in shape.
• The horn, turn signal lamp and
hazard lamp can be operated
without the key inserted. There-
fore, using these components
without the engine started can
discharge the battery.
WARNING
• Never touch the mu󰀪er or hot
covers until they are cooled
down after running the engine
or driving the tractor.
NOTE
• When setting the ignition switch to
the OFF position after operation,
the pump is operated to return
urea left in the urea pump and
injector back to the tank, making
a ticking sound. This is normal.
• Do not set the battery cut-off
switch to the OFF position or
disconnect the battery during this
state.
• This takes for approximately two
minutes.
TG300(HX9010,1001,1151,1301,1401)-수출(통합)-OM-05.indd 7TG300(HX9010,1001,1151,1301,1401)-수출(통합)-OM-05.indd 7 2022-06-24 오후 2:42:232022-06-24 오후 2:42:23