4
-
6
KEY SWITCH
(1) Key switch
(A) OFF (B) ACC
(C) ON (D) START
START (D)
The position "D" indicates "Start." In
order to start the engine, depress the
clutch pedal and turn the PTO switch
o. As soon as the engine is started,
release the key then the key will return
to the position "C."
OFF (A)
When the key switch is in the posi-
tion "A", the engine and all electrical
devices in the vehicle are turned o.
However, asher lights and turn signal
lights can be operated along with their
indication lamps on the dash board.
ACC (B)
When the key switch is turned to the
position "B", the asher lights and turn
signal lights can be operated.
ON (C)
The position "C" indicates the "ON "
position. As soon as the key switch
is turned to this position, the oil pres-
sure warning lamp and battery charge
warning lamp come on (these turn
o after the engine is started) and
the automatic preheating function is
activated.
The automatic preheating operation
is informed by illumination of the pre-
heat lamp on the instrument cluster.
In cold weather, preheat the engine
suciently until the preheat lamp goes
o (approx. 9 seconds).
HX1O492A
NOTE
• The ignition key is directional, so
it can be inserted only in a certain
direction. Also, be careful not to
leave the tractor unattended as
the same key is used for all KIOTI
tractors. It can be stolen.
• The horn, turn signal lamp, and
hazard lamp can be operated
without the key inserted.
CAUTION
• Stop the engine immediately if
the oil pressure warning lamp
does not go o after the engine
is started. The engine may be
severely damaged.
• If the battery charge warning lamp
does not go o after the engine
is started, check the electrical
systems, such as the alternator,
for damage. Continuing to use the
engine under this condition can
discharge the battery or damage
other electrical devices.
TG300(HX9010,1001,1151,1301,1401)-수출(통합)-OM-04.indd 6TG300(HX9010,1001,1151,1301,1401)-수출(통합)-OM-04.indd 6 2022-08-16 오전 11:08:092022-08-16 오전 11:08:09
To Next Page
Loading...
