Check if the seat is securely
locked after the seat adjust-
ment.
Do not adjust the seat while
driving. The seat may move
suddenly causing the loss of
control of the tractor.
•
•
WARNING
1. Adjust the seat and fasten the seat
belt.
M46O504A
(1) Seat
(2) Seat Adjustment Lever (Sliding)
nect the clip to a part of the frame
without paint.
6. Start the engine of the tractor
with the charged battery.
7. Start the engine of the tractor
with the discharged battery.
8. Disconnect the black cable from
the negative battery terminals of
both of the tractors.
9. Disconnect the red cable.
10. Run the engine for at least 30
minutes to charge the discharged
battery.
11. If the battery is discharged again,
replace it or check the charging
system, such as the alternator.
OPERATING THE TRACTOR
DRIVING
1. Check that the voltage of the dis-
charged battery is same as the
voltage of the other tractor or ve-
hicle for jump start. (Specication
for this tractor: 12V)
2. Check the length of the jump cable
and position another tractor near
the tractor with the discharged bat-
tery. Then, put all the shift levers
in the neutral position, apply the
parking brake, and stop the en-
gine.
3. We a r p r ote cti v e g l ass es a nd
gloves and open the hoods of both
tractors. Remove the battery termi-
nal cover as necessary.
4. Connect the alligator clips on both
ends of the red positive cable to
the positive terminals of both bat-
teries.
5. Connect one clip of the black neg-
ative cable to the negative terminal
of the normal battery and the other
clip to the tractor body with the dis-
charged battery. Make sure to con-
To Next Page
Loading...
