M46O511A
(1) Chocks (2) Parking Brake Lever
PARKING
1. This tractor is not equipped with a
separate parking brake. However
uses the brake pedals instead.
2. Pull the parking brake lever (2) up
with the brake pedals depressed
fully to engage the pedals with the
latch. If the braking force is insuf-
ficient, depress the pedals more
rmly.
3. Before leaving the tractor after
parking it, make sure to stop the
PTO lower the implement onto the
ground, and stop the engine.
4. If it is necessary to leave the trac-
tor with the engine running, put all
the shift levers in the neutral posi-
tion and apply the parking brake
rmly.
5. When parking the tractor on a
slope, stop the engine with the
parking brake applied and engage
the low speed gear. Also, put the
shuttle shift lever into the forward
driving position on an uphill and
into the reverse driving position on
a downhill.
The brake disc can be rap-
idly worn if you drive with the
parking brake applied.
Never park the tractor on a
steep slope in any circum
-
stance. A severe accident can
happen.
•
•
WARNING
6. If it is necessary to park the tractor
on a slope with the engine running,
chock all four wheels (1) and per-
form Steps 3 and 4 above.
7. In order to release the parking
brake, depress the brake pedals
rmly again.
To Next Page
Loading...
