To prevent accidents due to loss
of steering control:
If you turn at high speed, the
tractor can turn over.
Never use the differential lock
system turning at high and
low speeds. A serious acci
-
dent can occur.
•
•
WARNING
The tractor may move slowly
with the engine running even
though the main and shuttle
shift levers are in the neutral
position. This is normal and
is due to the fluid friction in
the transmission. This symp-
tom can easily occur when
the engine rpm is high, the
low speed gear is selected
by the range shift lever, and
the viscosity of the transmis-
sion fluid is high due to low
temperature. To prevent this
symptom, make sure to apply
the parking brake.
Get off the tractor after check
-
ing that the tractor is com-
pletely stopped and the park-
ing brake is rmly applied.
Do not park the tractor on tall
grass or hay. If grass or hay
touches the muffler, it can
cause re.
•
•
IMPORTANT
"Unlike a gas pedal, these HST
pedals act like a main speed
shift in a mechanical trac-
tor". Therefore, depress them
deeper to obtain higher speed
with lower torque and release
them to obtain lower speed
with higher torque.
For heavy load job, such as
front end loader operation,
use low or medium speed of
the range shift lever.
•
•
IMPORTANT
You should turn slowly by lowering
the engine rotation if possible.
TURNING DRIVING ON SLOPE
1. Please drive according to the con-
ditions of the slope at safe speed
so that the engine is not under
heavy load if possible.
2. Make sure to shift to the lower
gear in order to prevent the engine
from stalling on an uphill.
3. On the downhill slope, drive at low
speed.
To Next Page
Loading...
