M46O716A
CHANGING FRONT AXLE CASE OIL (N)
(1) Oil Filler Plug (2) Drain Plug
(3) Oil Check Plug
1 To drain the used oil, remove the
right and left drain plugs and fill-
4. Add new oil to the specied level
of the check plug through the oil
ller. (Refer to "Lubrication" in the
chapter "Service")
5. Tighten the oil filler plug and oil
check plug after replenishment.
6. Check the oil level after 15 min-
utes and add oil as necessary.
(1) Oil Check Plug
M46O745A
2.0 L (0.53 U.S.gal.)
ing plug at the front axle case and
drain the oil completely into the oil
pan.
2. After draining reinstall the drain
plugs.
3. Remove the oil filler plug and
oil level check plug. (commonly
shared component)
To Next Page