1. Disengage the PTO, lower all
implements, place all control le-
vers in the neutral position, set
the parking brake, stop the engine
and remove the key.
WHEN PARKING THE TRACTOR
T66O120a
(1) PTO Shaft Cover (2) PTO Shaft Cap
WHEN OPERATING THE PTO
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, cleaning
or servicing any PTO driven equip-
ment.
2. Keep the PTO shaft cover in place
at all times. Replace the PTO shaft
cap when the shaft is not in use.
3. Before installing or using PTO
driven equipment, read the work-
M46O103a
shop manual and review the safety
labels attached to the equipment.
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height
and check that at least 1/4 of
the total length of the tele-
scopic section of the drive
shaft is engaged.
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
•
•
•
•
WARNING
To Next Page
Loading...
