Daedong KIOTI CS2610 - Adjustment of Lift ROD

CS2610
6
-
6
M46O602A
(1) Lift Rod (2) Turnbuckle
(3) Lock Nut
1. Adjust the implement level bal-
anced by turning the turnbuckle.
2.Afteradjustment,xitwiththelock
nut
ADJUSTMENT OF LIFT ROD
(1) Top Link (2) Pin
(3) Retainer Pin (4) Top Link Hook
1. Install the top link to the desired
position, and install the pin and re-
tainer pin.
2.FixToplinkwithxednutafterad-
justing top link.
M46O603A
ADJUSTMENT OF TOP LINK
Stop the engine and lower the
attachment to the ground prior
to disconnecting the lift rod
from the lower link. Check that
the attachment has proper
support and that there’s pres-
sure remaining in the hydrau-
lic system to remove the lift
rod holding the pin. To elimi-
nate the remaining pressure,
move the hydraulic adjusting
lever back and forth several
times.
•
WARNING
When there is no implement at-
tached, fix the lower link to the
check link (LH/RH) so that it
does not contact with the rear
wheel.
Secure the top link to the stor
-
age hook.
•
•
NOTE
M46-EU,AU-EEC인증용-06.indd 6 2017-04-26 오전 11:41:52