6. If tension is incorrect, loosen the
alternator mounting bolts and, us-
ing a lever placed between the al-
ternator and the engine block, pull
the alternator out until the deec-
tion of the belts falls within accept-
able limits.
7. Replace the fan belt if it is dam-
aged or cracked.
A deection between
7 ~ 9 mm (0.28 ~ 0.35 in.) when the belt
is pressed in the middle of the span.
(1) Battery
Mishandling the battery shortens the
service life and adds to maintenance
costs. If the battery is insufficiently
charged, the headlights may dim and
the engine is hard to start. It is im-
portant to inspect the battery periodi-
cally.
1. The battery cable should always
be clean and firmly connected.
When installing a new or used bat-
tery, clean its terminals and the
end of the cable.
BATTERY (W)
M46O727A
2. Check the electrolyte level and
add distilled water if necessary.
3. Check the battery and cable for
damage and corrosion.
4. Apply grease to the terminals and
cable end in order to prevent cor-
rosion.
-
furic acid that can burn you.
Do not allow the battery fluid
to contact your eyes, skin, or
-
dentally get it in your eyes or
contact with water and contact
your doctor.
•
•
WARNING
-
fore checking belt tension.
•
CAUTION
4. In order to set the belt tight, move
the upper part of the alternator
backward.
5. Apply moderate thumb pressure to
the belt between pulleys.
To Next Page
Loading...
