Daedong KIOTI CS2610 - Adjustment of Stabilizer; Draft Hitch and Trailer

6
6
-
7
3-POINT HITCH IMPLEMENT OPERATION
M46O604A
ADJUSTMENT OF STABILIZER
(1) Check Link (2) Turnbuckle
1. Adjust the check link control hori-
zontal sway of the implement. It is
also used to set the implement on
the back of the tractor in center.
2. To adjust the check link, pull out
the pin and adjust it until the de-
sired transverse moving distance
is obtained.
3.Fitthepintothexedholefornor-
mal operation and long hole (mov-
ing) for draft work.
C56O174A
DRAFT HITCH AND TRAILER
(1) Draw Bar
The draw bar is used to pull an im-
plement, such as a trailer. This trac-
torisequippedwithanedrawbar.
Makesuretocheckthemax.towing
weightofthetrailerandmax.vertical
load that can be applied to the draw
bar.
M46O605A
When using an implement that
is attached to the draw bar,
such as a trailer, check if the
towing hitch is rmly attached.
•
CAUTION
M46-EU,AU-EEC인증용-06.indd 7 2017-04-26 오전 11:41:53