EasyManua.ls Logo

Daedong KIOTI CS2610 - Checking Radiator Hose and Clamp (Z); POWER STEERING Line (Aa)

Daedong KIOTI CS2610
192 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CS2610
7
-
28
M46O731A
(1) Clamp (2) Hose

Check to ensure the radiator hoses
are free from damage and are tight-
ened properly every 200 hours or ev-
ery 6 months, whichever comes rst.
1. If the hose clamps are loose or
water leaks from hose, tighten
clamps securely.
2. If the radiator hoses are swollen,
hardened, cracked, or otherwise
damaged, you must replace the
hoses. Failure to do so could lead
to coolant loss and engine damage.
It is a good practice to replace the
radiator hoses every two years.

Take the following actions in the
event the coolant temperature reach-
es the boiling point, what is called
"Over-heating".
1. Stop the machine in a safe place
and keep the engine idling.
2. After 5 minutes of unloaded idling,
shut the engine down.
3. Keep yourself away from the trac-
tor for another 10 minutes or until
steam has stopped blowing out of
the engine.
4. Make sure that there is no danger
and repair the cause of the over-
heating according to the manual’s
instruction. (Make sure to refer to
"Engine troubleshooting" in chap-
ter 8 before starting the engine)
(1) Power Steering Oil Line
M46O732A

1. Check to see that all hydraulic
lines and hose ttings are tighten
and undamaged.
2. If damage is found you should re-
place the hose at once.
M46-EU,AU-EEC인증용-07.indd 28 2017-04-25 오후 5:00:08

Table of Contents

Related product manuals