5. Apply a thin lm of clean oil onto
the O-ring of a new lter.
6. Tighten the filter firmly until it
contacts the mounting surface.
Tighten the lter a half turn further
by hand.
7. Run the engine for a few minutes
and then stop it after installing a
new lter.
8. Check the uid level and add uid
to the specied level.
9. Make sure that the transmission
uid does not leak through the seal.
13 L (3.4 U.S.gal.)
(1) Gauge (2) Oil Filler Plug
(A) Oil level is acceptable within range
M46O705A
(1) Air Bleeding Plug
M46O715A
before changing the fluid or
-
ly. You can get burnt by hot
•
•
CAUTION
the hydraulic system, use only
-
mediately after changing the
transmission fluid. Run the
-
age to the transmission.
•
•
When adding the fluid, un-
the left of the hydraulic cylin-
der. Other-wise, the fluid can
•
To Next Page
Loading...
