EasyManua.ls Logo

Daedong KIOTI CS2610 - Page 149

Daedong KIOTI CS2610
192 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
7
-
15
MAINTENANCE
7. Run the start motor for approx. 10
seconds to deliver oil to each part.
8. Run the engine for approx. 5 min-
utes and check if the oil warning
lamp comes on. If it does not come
on, stop the engine. (It is normal
that the oil warning lamp is off
while the engine running)
9. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.

3 L (0.8 U.S.gal.)
The e ngine oil i s ver y hot
while the engine is running
or right after the engine is

burned.
Avoid oil contact while chang-
ing or adding engine oil and


   -
tact with the engine oil may
ca us e s ki n di so rd e r s a nd
skin cancer. If skin contact is
made, wash thoroughly with



of children.
WARNING

   
before changing the oil or re-

Check the engine oil level be-
   
tractor. If the engine oil is insuf-
-
aged, and this is not covered by
warranty. Be sure to add engine
oil when its level is below the

    

   
-
cable reg-ulations when dis-

CAUTION
Use only KIOTI genuine en-
gine oil and filters to insure
-
ity of the engine.

The engine oil filter should be
replaced when changing the en-
gine oil.
NOTE
M46-EU,AU-EEC인증용-07.indd 15 2017-04-25 오후 5:00:00

Table of Contents

Related product manuals