IP: Device IP such as 10.7.8.122.
Port: Port value. The default setup is 554. You can leave in blank if you
are using default value.
Channel: channel number. It starts with 1. If it is channel 2, then
channel=2.
Subtype: bit stream type. The main stream is 0(subtype-0),subtype is
1(subtype=1).
For example, if you want to get the substream of the channel 2, the URL is:
rtsp://admin:admin@10.12.4.84:554/cam/realmonitor?channel=2&subtype=1.
If there is no authentication, there is no need to specify user name and
password, you can use the following format:
rtsp://ip:port/cam/realmonitor?channel=1&subtype=0
5.6.2.4 DDNS
From main window->Setup->Network->DDNS, the interface is shown as below. See Figure 5-26.
The DDNS is to set to connect the various servers so that you can access the system via the
server. Please go to the corresponding service website to apply a domain name and then access
the system via the domain. It works even your IP address has changes.
When the device directly connects to the exterior network, please disable UPnP function.
Figure 5-26
Please refer to the following sheet for detailed information.
To Next Page
Loading...
