222
Figure 5-113
5.13 Alarm
Click alarm function, you can see an interface is shown as Figure 5-114.
Here you can set device alarm type and alarm sound setup (Please make sure you have enabled audio
function of corresponding alarm events.).
Figure 5-114
Please refer to the following sheet for detailed information.
System alarms when motion detection alarm
occurs.
System alarms when camera is viciously masking.
System alarms when disk is full.
System alarms when disk error occurs.
It refers to the on-off signal from the network
camera. It can activate the NVR local activation
operation.
System can generate an alarm when the network
camera and the NVR are disconnected.
To Next Page
Loading...
