72
Figure 4-40
Step 7 Click Finish to complete the setup.
4.2.3 Short-Cut Menu to Register Camera
If you have not registered a remote device to a channel, please go to the preview interface to add.
Step 1 On the preview interface,
Move your mouse to the center, there is an icon “+”. See Figure 4-41.
Figure 4-41
Step 2 Click “ +”, device pops up interface to add network camera. Refer to chapter 4.1.4.4 Registration
for detailed information.
4.2.4 Image
It is to set network camera parameters according to different environments. It is to get the best video
effect.
From main menu->setting->camera->image, you can see the image interface is shown as below. See
Figure 4-42.
To Next Page
Loading...
