User's Manual
182
Step 3 Click
Apply
.
5.7.5.2 Privacy Masking
You can mask certain areas of the video image for privacy protection.
Procedure
Step 1 Select
Main Menu
>
CAMERA
>
Overlay
>
Privacy Masking
.
Figure 5-70 Privacy masking
Step 2 Select a channel.
Step 3 Click to enable privacy masking.
Step 4 Click
Add
, select the masking type and color, and then draw mosaic or color blocks in the
image as needed.
A masking block appears on the video image.
●
The number of masking blocks that you can add might differ depending on the camera.
You can add up to 24 masking blocks.
●
Click
Clear
to delete all masking areas. Click to delete a masking area.
Step 5 Drag the masking block to a desired position and then configure the type, color and other
parameters.
Step 6 Click
Apply
.
5.7.6 Configuring Encoding Settings
You can set video bit stream and image parameters.
5.7.6.1 Configuring Audio and Video Encoding Settings
You can set audio and video encoding parameters such as bit stream type, compression, and
To Next Page
Loading...
Need help?
General
