User's Manual
310
Figure 5-200 Parameters (Registration mode)
Table 5-55 Parameters description
Parameter Description
Alarm Trigger Condition
Receive an alarm event according to the set rule and
display it on the live page.
●
Match attributes alarm: When the detected workwear
matches the set attributes, an alarm is triggered.
●
Mismatch attributes alarm: When the detected workear
does not match the set attributes, an alarm is triggered.
Min Duration
Set the minimum time for the person wearing the
workwear to appear in the detection area until an alarm is
triggered.
Repeat Alarm Time
Set the repeat alarm time.
If the alarm state persists, when reaching the repeat alarm
time, the alarm is triggered again.
Workwear
Select
Detection Mode
.
●
Detect by attribute: You need to set the detection
range.
●
Registration mode: You need to link the workwear
database that has been set for the front-end camera.
Receive an alarm event based on the linked workwear
database and display it.
1. Click
Settings
next to
Linked Workwear Database
.
2. Select
workwear database1
, and then click
OK
.
Hat
Select
Detect for Attributes
,
Detection Range
, and
Color
.
Face Mask
To Next Page
Loading...
Need help?
General
