User's Manual
316
Figure 5-207 Set the camera audio
2. Select the channel to add the camera audio, and then click
OK
.
If the camera audio configuration of multiple channels has been configured, when an
alarm event is triggered, the multiple channels can link to the corresponding camera
audio.
Step 8 Click
Setting
next to
Remote Warning Light
to configure the remote warning light.
1. Click
Add
, and the page displays all channels that have successfully connected and
support the remote warning light configuration.
If a certain channel is selected in
Alarm-in Port
and supports the remote warning light
configuration, the remote warning light configuration of this channel will be displayed
by default, and you cannot delete it.
a. Select
Mode
and
Flicker Frequency
of the remote warning light.
b. Configure
Stay Time
, supports a maximum of 30 seconds.
c. Click
Copy
to copy the remote warning light configuration of the current channel to
other channels.
d. Click to delete one channel. Select multiple channels, and then click
Delete
to
delete multiple channels.
To Next Page
Loading...
Need help?
General
