●
When connecting to a third-party IPC, make sure that the IPC supports ONVIF protocol and
DHCP is enabled.
Procedure
Step 1 Select Main Menu > NETWORK > Switch.
Figure 5-239 Switch
Step 2 Select Route or Bridgein Mode as needed.
The default mode is route.
Step 3 Congure IP address, subnet mask, and default gateway.
In the bridge mode, you cannot congure these parameters.
In the route mode, you can click to enable Auto IP Allocation, and the function is
turned on by default.
Do not set the IP address to the same network segment with the Device. We recommend
you use the default setting.
Step 4 Click Apply.
Related Operations
When connecting IP camera to PoE port, if all the channels are occupied, the system prompts you
whether to take place of one channel.
Table 5-72 PoE operation
PoE operation Description
Connect to PoE port
When an IPC is connected to the PoE port, the system automatically
assigns the IP address to the IPC according to the set IP segment. The
Device will try the method of arp ping to assign the IP address. If DHCP is
enabled on the Device, the Device will use DHCP to assign the IP address.
●
When IP address is successfully set, the system will broadcast through
the switch function. If there is a response from the IPC, it means the
connection is successful, and the Device will log in to the IPC. You can
nd the corresponding channel occupied and there is a PoE icon at
the upper-left corner.
●
You can also view PoE status such as channel number and PoE port
number on the Added Device list in Main Menu > CAMERA >
Camera List.
Disconnect PoE port
When an IPC is disconnected form PoE port, you will nd the information
of Failed to nd network host on the live channel window.
User's Manual
366
To Next Page
Loading...
