User's Manual
387
Figure 5-279 Basic services
Step 2 Enable the system services.
There might be safety risk when
Mobile Push Notifications
,
CGI
,
ONVIF
,
SSH
and
NTP
Server
is enabled. Disable these functions when they are not needed.
Table 5-78 Basic service parameters
Parameter Description
Mobile Push Notifications
After enabling this function, the alarm triggered by the NVR can be
pushed to a mobile phone. This function is enabled by default.
CGI
If this function is enabled, the remote devices can be added through
the CGI protocol. This function is enabled by default.
ONVIF
If this function is enabled, the remote devices can be added through
the ONVIF protocol. This function is enabled by default.
NTP Server
After enabling this function, a NTP server can be used for time
synchronization. This function is enabled by default.
SSH
After enabling this function, you can use SSH service. This function is
disabled by default.
Enable Device Discovery
After enabling this function, the NVR can be found by other devices
through searching.
To Next Page
Loading...
Need help?
General
