26
Figure 5-14
Set according to actual network access mode. Step 4
Static IP
Select “Static IP”. 1.
Enter “Local IP”, “Subnet Mask” and “Gateway”. 2.
DHCP
Select “DHCP” to obtain IP address automatically.
Click [OK] to save the settings. Step 5
5.1.2.3 Product Info Settings
Set VTH “Room No.”, “Type” and “Master IP”.
Select “System Config>Project Settings”. Step 1
The system pops up “Password” prompt box.
Enter the password set during initialization, and click [OK]. Step 2
Click [Product Info]. Step 3
The system displays “Product Info” interface, as shown in Figure 5-15.
To Next Page
Loading...
