Dahua VTO2000A-C - VTH Settings (Version 3.1)

24
Figure 5-11
Select room no. and click “OK”. Step 5
The interface displays room no. info and corresponding button turns green, as shown in
Figure 5-12.
Figure 5-12
Click “Save” to save the settings. Step 6
After saving, reboot the device to take effect.
5.1.2 VTH Settings (Version 3.1)
5.1.2.1 Initialization
Set the password and bind your Email.
 Password: it is used to enter project setting interface.
 Email: it is used to retrieve your password when you forget it.
Power on the device. Step 1
The system displays “Welcome” and enters “Device Initialization” interface, as shown in
Figure 5-13.