Dahua VTO2000A-C User Manual

28
Figure 5-16
Add VTO or fence station. Step 4
 Add main VTO.
In Figure 5-16, enter main VTO name, IP address, “User Name” and “Password”. 1.
Switch “Enable Status” to . 2.
 “User Name” and “Password” shall be consistent with WEB login user name
and password of VTO. Otherwise, it will fail to connect.
 “Enable Status” of main VTO is “ON” by default. After setting VTO info, please
turn it off and then reboot, in order to put it into effect.
 Add fence station.
Press to switch to sub VTO setting interface. 1.
Select device type to be “fence station”; enter sub VTO name (fence station name), 2.
VTO middle no. (fence station middle no.), “User Name” and “Password”.
Switch “Enable Status” to . 3.
Click [OK] to save the settings. Step 5
5.1.3 VTH Settings (Version 4.0)
5.1.3.1 Initialization
Set the password and bind your Email.
 Password: it is used to enter project setting interface.
 Email: it is used to retrieve your password when you forget it.

Dahua VTO2000A-C Specifications

General

Brand	Dahua
Model	VTO2000A-C
Category	Measuring Instruments
Language	English