Dahua VTO2000A-C User Manual

59
Parameter
Description
rtsp://ip:port/cam/realmonitor?channel=1&subtype=0
Table 7-2
Click “OK” to save the settings. Step 5
In case that the port is modified, enter “http://VTO IP: WEB port no.” in the browser, to
visit WEB interface of this VTO.
7.5.4 DDNS Server
In case of frequent changes in IP address of the device, DDNS (Dynamic Domain Name Server)
dynamically updates the relation between domain name and IP address on DNS server, and
ensures that users are able to visit the device through domain name.
 Before configuration, please check if the device supports DDNS server; login
corresponding DDNS website to register username, password and domain name info.
 After the user registers successfully on DDNS website and logins, view the registered
user’s all connected devices.
Select “System Config > Network Config > DDNS”. Step 1
The system displays “DDNS” interface, as shown in Figure 7-17.
Figure 7-17
Tick “Enable” to enable DDNS server function. Step 2
Set parameters and refer to Step 3
Parameter
Step 4
Description
Server Type
Server type refers to name of DDNS server provider.
Relation between server type and server name is as
follows.
Dyndns DDNS address is: members.dyndns.org.

NO-IP DDNS address is: dynupdate.no-ip.com.

Server Name
Server Port
Port no. of DDNS server.
Realm
Domain name registered by the user at the website of
DDNS server provider.
User
User name and password obtained from DDNS server
provider. The user needs to register (including user
Password

Dahua VTO2000A-C Specifications

General

Brand	Dahua
Model	VTO2000A-C
Category	Measuring Instruments
Language	English