Dahua VTO2000A-C User Manual

37
6 Basic Function
6.1 Call Function
6.1.1 Call Management Centre
The system provides different calling ways depending on connected module.
 If modular VTO connects keyboard module, press on the keyboard module to call the
management centre.
 If keyboard module is not connected, press call key of camera module to call the
management centre.
Configure the following parameters before calling.
Select “System Config >LAN Config”. Step 1
The system displays “LAN Config” interface.
Select “Register to the MGT Centre”; set “MGT Centre IP Address” and “MGT Port Step 2
No.”.
Register the VTO at management center.
 To call from keyboard module, ensure that VTO has been registered at
management centre.
 To call by pressing the call key of camera module, it is necessary to enable “Call
VTS or Not”.
Set “Call VTS Time” and select “Call VTS or Not”. Step 3
Enable to call the management centre within the set time period.
Click “OK” to save the settings. Step 4

Dahua VTO2000A-C Specifications

General

Brand	Dahua
Model	VTO2000A-C
Category	Measuring Instruments
Language	English