Daikin 10 - Page 137

134
8
Disassembling Procedure
Work Procedure Point
WARNING
Before disassembling work, be sure
to turn OFF all power supplies.
1 Many of the DC fan motor (M3F),
electronic expansion valve
for main circuit (Y1E), motor
operated valve for hot gas (Y2E),
high pressure switch (S3PH),
and connection wiring (lead
wires) to the other electrical
components pass through the
left and right wiring ports, instead
of the conventional grommet.
To remove these wires, follow the
procedure below.
① Unscrew one screw and
remove the wiring port
cover.
② Peel off the sealing
material inside. (*1)
③ Pull out the lead wire of
the part to be replaced.
1.
Removing the wiring port
cover and sealing material.
*1
Once the sealing material
of the wiring port is
removed, its dust-preventive
performance is degraded.
扌
Change the removed sealing
material with a new one
before taking in lead wire
again.
Wiring port cover
Wiring port cover
(Sample: right side)
Remove
while pushing.
Sealing
material
Procedure for Removing Wiring
Inside Wiring Port
00_PB00540A_M10.indb 134 2023/08/09 12:59:17