Operation Manual SiBE06-708_A
71 Operation Manual
18
TIMER Operation
•
1.
is displayed.
2.
•
3.
•
4.
•
•
ATTENTION
•
•
•
1, 3
4
2
(Example)
Combined
Display
To use ON TIMER
operation
Check that the clock is correct. If not, set
the clock to the present time.
Press “ON TIMER button”.
blinks.
Press “SELECT button” until
the time setting reaches the
point you like.
Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
Press “ON TIMER button”
again.
The TIMER lamp lights up.
To cancel ON TIMER
operation
Press “CANCEL button”.
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
A sample setting for combining the two timers is shown below.
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
In the following cases, set the timer again.
After a breaker has turned OFF.
After a power failure.
After replacing batteries in the remote controller.
To Next Page
Loading...
Need help?
General
