DF4510HD | DF4910HD | DDF4510HDV-IM/-SM | DDF4910HDV-IM/-SM
www.dallmeier.com 14
4.5 Outdoor Use
4.5.1 Box Cameras DF4510HD & DF4910HD
The box cameras DF4510HD and DF4910HD are designed for indoor use.
For outdoor use, the cameras must always be installed in a proper weather-proof hous-
ing.
However, note that direct sunlight can cause very high temperatures inside the housing.
In this case, it is absolutely necessary to use a ventilated, temperature-controlled weath-
er-proof metal housing and a sunshield where required.
In addition, a metal slide should always be used if the cameras are installed in a (weath-
er-proof) housing to ensure optimal heat dissipation.
4.5.2 Dome Cameras DDF4510HDV-IM & DDF4910HDV-IM
The dome cameras DDF4510HDV-IM and DDF4910HDV-IM (in-ceiling mount variants)
are exclusively designed for indoor installations.
An outdoor installation is prohibited and may result in malfunction, damage, data loss and
loss of warranty.
4.5.3 Dome Cameras DDF4510HDV-SM & DDF4910HDV-SM
The dome cameras DDF4510HDV-SM and DDF4910HDV-SM (surface mount variants)
are designed for indoor installations.
However, an outdoor installation may be permitted, but only in compliance with the follow-
ing instructions/recommendations:
• Use only IP67 (Ingress Protection 67) approved components and assemblies.
• Always use the delivered O-rings.
• Adhere the delivered adhesive-backed gasket to the bottom of the housing base.
• Always use the delivered cable gland (or equivalent) for the cable feedthrough.
• Protect the device from direct inuence of weather conditions (rainfall, direct sunlight, etc.).
• Always use a protected installation site (e.g. under a canopy).
• For wall mount installations, align the camera housing with the cable gland pointing
down whenever possible.
To Next Page
Loading...
