dallmeier DF4510H - Manual Configuration; Dhcp

DF4510HD | DF4910HD | DDF4510HDV-IM/-SM | DDF4910HDV-IM/-SM
www.dallmeier.com 49
9.1.1 Manual Conguration
If no DHCP server is available in your LAN or if you want to assign the network settings
manually, proceed as follows:
 Pay attention to the designated and valid IP address ranges in your network.
 Ensure that the Get IP settings from DHCP checkbox is deactivated.
 Enter the IP address you want to assign to the device.
 Enter the Netmask.
 Enter the Gateway address.
 If required, congure the available DNS settings (as described above).
 Deactivate the Allow IP-Finder network conguration
5)
checkbox if not required.
 Finally, conrm with OK.
The connection to the device is terminated and the new network settings are assigned.
9.1.2 DHCP
To have a DHCP server assign the network settings automatically, proceed as follows:
 Ensure that an active DHCP server is available in your local area network (LAN).
 Activate the Get IP settings from DHCP checkbox.
 If required, congure the available DNS settings (as described above).
To send the Host name to the DHCP server, deactivate the
Get host name from DHCP checkbox and enter a specic host name.
 Deactivate the Allow IP-Finder network conguration checkbox if not required.
 Finally, conrm with OK.
The connection to the device is terminated and the new network settings are assigned by
the DHCP server (pay attention to the lease duration).
The newly assigned network settings can be determined by the MAC address of the de-
vice using the IP-Finder or on the DHCP server.
The IP-Finder must be executed in the same LAN in which the device is located.
5) IP-Finder: Dallmeier software for the determination and conguration of network-compatible Dallmeier devices