Dalsa Piranha 2 Series - Page 75

75 Piranha 2 User’s Manual
03-032-00493-14 Teledyne DALSA
Code
Command
Short
Form
Parameters
Description
sensor pixel count.
20
reset_camera
rc
Reset the entire camera
(reboot).
21
reset_pixel_coeffs
rpc
Reset the pixel coefficients to 0.
22
restore_factory_settings
rfs
Restore the camera’s factory
settings. FPN and PRNU
coefficients reset to 0.
23
restore_user_settings
rus
Restore the camera's last saved
user settings and FPN and
PRNU coefficients.
24
set_analog_offset
sao
t i
Set the analog offset. The first
parameter is the tap selection 1
to 4, 0 for all taps. The second
parameter controls the digital
analog convertor (DAC), in a
range from 0 to 1023, that sets
analog offset. Offset increases
with higher values.
25
set_baud_rate
sbr
i
Set speed of serial
communication port. Baud
rates: 9600, 19200, 57600, and
115200. Default baud: 9600
26
set_camera_id
sci
s [s]
Set camera ID. The first
parameter is a character A to
Z, or 0 to 9. The second
optional parameter is the serial
number of the addressed
camera.
27
set_data_mode
sdm
i
Set the data mode of camera
output to:
0: 8-bit, A/ B/ C/ D ports, single
processor
1: 10-bit, A/ B/ C and D/ E/ F
ports, single processor
2: 8-bit, A/ B and D/ E ports,
dual processor
3: 10-bit, A/ B/ C and D/ E/ F
ports, dual processor
28
set_digital_offset
sdo
t i
Subtracts the input value from
the video signal prior to the
PRNU correction. The first
parameter is the tap selection 1
to 4, 0 for all taps. The second
parameter is the offset in a
range from 0 to 511. Use in
calibrated mode only.
Parameters:
i = integer
f = float
t = tap selector
s = string
x1 = pixel start
number
x2= pixel end number
[]= optional
parameter
All manuals and user guides at all-guides.com