11
Dane-Elec. All rights reserved 2010
4 Getting started
4.1 Installing my-Ditto
1. Connect the Ethernet cable from my-Ditto to your router (or ISP box)
2. Connect to the Power Supply
3. Switch the Power Button to On
4.2 To Turn my-Ditto Off
Press the RELEASE button until a beep is heard. All LED indicators will turn off, with the
exception of the LAN LED. Now wait an additional 10 seconds and then switch the power
button to off on the back of the device.
Note: Before you start, make sure your router is working and connected to the Internet.
Powering up should take approx. 2 minutes. Once completed, the LED indicators will become
illuminated, as shown in the above image.
To Next Page
Loading...
