96
Dane-Elec. All rights reserved 2010
Case:
HDD1 or HDD2 LED is flashing.
Solution:
The hard disk drive is faulty and should be replaced.
13.5 Backup Troubleshooting
Case:
My-Ditto was not able to find this computer on the local network.
Solution:
In order to backup your selected items from this computer both the computer and my-Ditto
must be connected to the same network.
Case:
Backup was not completed because of local network disconnections.
Solution:
An excessive amount of disconnections to the network has prevented the backup operation
to complete its action.
During the next few hours my-Ditto will try again automatically to complete the operation.
Case:
Not enough space on my-Ditto's disks.
Solution:
There is not enough space on your disks in order to complete the backup of the selected
items. Delete any unneeded data from the disks or expand your capacity further by adding
an additional disk.
Capacity information can be seen in the Disks tab under the Settings in my-Ditto application.
Note: If you’re my-Ditto have 2 HDD in separate mode, backed up content will appear under
Disk1. You may need to offload data onto Disk2 in order to free up space on Disk1.
Case:
I/O error.
To Next Page
Loading...
Need help?
General
