Danfoss AK-SM 850 User Manual

I/O Comm tab
If Controllers (Danfoss Evap & Pack, Power meters) and, I/O has
been used in the control conguration (Lighting, HVAC, Refrigera-
tion etc.), these devices can be seen under the I/O Comm tab.
The I/O Comm tab allows any oine communication alarms to be
congured. The example below shows an evaporator controller
(address 1) with the alarm level set to ‘Normal’ & alarm action ‘1’.
These factory settings can be changed in this page.
Any AK I/O points used in the AK-SM system can be found on this
page, with the associated alarm level and actions set. The factory
settings can be changed as required.
Calculations & Other
If any calculations have been dened in the AK-SM
system, alarms can be associated with these. Use
the Calculations tab to set appropriate alarm levels
and actions.
28 User Guide Lit. no. USCO.PI.R1.E1.02 © Danfoss 07-2013 AK-SM 850

Danfoss AK-SM 850 Specifications

General

Brand	Danfoss
Model	AK-SM 850
Category	Controller
Language	English