Danfoss AK-SM 850 User Manual

NOTES
Glossary of terms
RMT Remote Management Tool
Viz Visual le. Used in the RMT tool and sent to the AK-SM for graphic Site View
System View Central page of AK-SM that displays all congured control points
Site View Custom graphic page with mapped system parameters
AK I/O: Danfoss AK Input / Output modules
Bd-Pt: Board & Point address location
Alarm Levels: Disabled = no alarm action
Log Only = logs alarm in database - no external action
Normal = Activate alarm output (once)
Severe = Activate alarm output (repeat based on severe repeat time)
Critical = Activate alarm output (repeat based on critical repeat time)
MAI Master Application Image
CSI Compressed Software Image
FAI Factory Application Image
IP Internet Protocol
EDF Extended Device File (a le that represents the physical device)
CAT (seen in EDF list) Category (1=Evap, 2=Pack, 8=HVAC, 16=Energy meter, 34=AKD102)
Relative schedule When set a relative schedule will oset against the operating hours (set under cong/time)Host
Communications The connection (via Ethernet) of one or more AK-SM units. The connection between units is
known as ‘host network’
Danfoss http://danfoss.com
Veris Industries™ http://www.veris.com/
Carlo Gavazzi™ http://www.carlogavazzi.com/
Continental Control Systems™ http://www.ccontrolsys.com/w/Home
72 User Guide Lit. no. USCO.PI.R1.E1.02 © Danfoss 07-2013 AK-SM 850

Danfoss AK-SM 850 Specifications

General

Brand	Danfoss
Model	AK-SM 850
Category	Controller
Language	English