Danfoss AK-SM 850 - Page 50

Example of Conversion Factors Tab
Conversion Factors
Conversion factors are used for sensors that have an output range
or range-to-value relationship not already dened as one of the
named “types” in the sensor input conguration list box. The fol-
lowing example highlights the Conversion Factor screen.
No of conversion factors: Enter the required amount of
conversion factors
Conv 1: Name for conversion factor (user changeable)
Units: Select from a range of unit types:
psi
Bar
°F
%
°C
ppm (Parts Per million)
V (Volts)
Amp
Kw
kWh
Hz
gpm (gallons per min)
fps
pH
fc
lpm (litres per minute)
lps (litres per second)
Minimum Input:
Maximum Input:
Minimum output:
Maximum output:
Lux:
Conversion Factor Tab
Depending on control require-
ments the screen layout may
dier.
50 User Guide Lit. no. USCO.PI.R1.E1.02 © Danfoss 07-2013 AK-SM 850