Danfoss FC 300 Operating Instruction

FC 300 Operating Instructions
How to Read these Operating Instructions
Chapter 3, How to Install, guides you through
mechanical and technical installation.
Page divider for How to Install
Chapter 4, How to Programme,showsyou
how to operate and programme the FC 300
via the Local Control Panel.
Page divider for How to Programme.
Chapter 5, General Specifications , entails
technical data about FC 300.
Page divider for G eneral Specifications.
Chapter 6, Troubleshooting, assists you in solving
problems that may occur when using FC 300.
Page divider for Troubleshooting.
Available literature for FC 300
- The VLT
®
AutomationDrive FC 300 Operating Instructions provide the neccessary
information for getting the drive up and running.
- The VLT
®
AutomationDrive FC 300 Design Guide entails all technical information about the drive and
customer design and applications including encoder, resolver and relay options.
- The VLT
®
AutomationDrive F C 300 Profibus Operating Instructi ons provide the information required
for controlling, monitoring and programming the drive via a Profibus fieldbus.
- The VLT
®
AutomationDrive FC 300 Device Net Operating Instructions provide the information required
for controlling, monitoring and programming the drive via a DeviceNet fieldbus.
- The VLT
®
AutomationDrive FC 300 MCT 10 Operating Instructions provide information
for installa tion and use of the software on a P C.
- The VLT
®
AutomationDrive FC 300 I P21 / TYPE 1 Instruction provides information
for installing the IP21 / TYPE 1 option.
- The VLT
®
AutomationDrive FC 300 24 V DC Backup Instruction provides information
for installing the 24 V D C Backup option.
Danfoss Drives technical literature is also available online at www.danfoss.com/drives.
4
MG.33.A7.02 - VLT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Brand	Danfoss
Model	FC 300
Category	DC Drives
Language	English