Danfoss FC 300

9-00 Setpoint
Range: Function:
0
*
[0-65535] This parameter receives cyclical reference from a Master Class
2. If the control priority is set to Master Class 2, the reference
for the frequency converter is taken from this parameter,
whereas the cyclical reference will be ignored.
9-07 Actual Value
Range: Function:
0
*
[0-65535] This parameter delivers the MAV for a Master Class 2. The pa-
rameter is valid if the control priority is set to Master Class 2.
9-15 PCD Write Configuration
Array [10]
None
3-02 Minimum Refer-
ence
3-03 Maximum Refer-
ence
3-12 Catch Up/Slow
Down Value
3-41 Ramp 1 Ramp
Up Time
3-42 Ramp 1 Ramp
Down Time
3-51 Ramp 2 Ramp
Up Time
3-52 Ramp 2 Ramp
Down Time
3-80 Jog Ramp Time
3-81 Quick Stop
Ramp Time
4-11 Motor Speed
Low Limit [RPM]
4-13 Motor Speed
High Limit [RPM]
4-16 Torque Limit Mo-
tor Mode
4-17 Torque Limit
Generator Mode
7-28 Minimum Feed-
back
7-29 Maximum Feed-
back
8-90 Bus Jog 1 Speed
8-91 Bus Jog 2 Speed
FC 300 Programming Guide 2. How to Programme
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark 135
2