Danfoss FC 300

R
Ramp 1 Ramp Down Time 78
Ramp 1 Ramp Up Time 77
Ramp 1 Type 77
Ramp 2 Ramp Down Time 79
Ramp 3 Ramp Down Time 81
Ramp 3 Ramp Up Time 81
Ramp 4 Ramp Down Time 82
Ramp Delay 85
Ramp Time 85
Rated Motor Speed 5
Rcd 7
Reference Source 1 74
Regional Settings 28
Relative Scaling Reference Source 75
Relay Outputs 101
Reset 14
Reset Control Word Timeout 129
Reset Kwh Counter, 15-06 182
Reset Mode, 14-20 174
Reset] Key On Lcp 40
Rfi, 14-50 179
Rotor Leakage Reactance (x2) 48
Rotor Resistance (rr) 48
Running Hours, 15-01 181
S
Serial Communication 6
Sl Controller Mode, 13-00 153
Special Functions 171
Speed Pid Feed Forward Factor 123
Speed Pid Lowpass Filter Time 123
Start Delay 55
Start Delay 55
Start Function 55
Start Function 55
Start Select, 8-53 132
Start Speed [hz] 56
Start Speed [rpm] 56
Stator Leakage Reactance 46
Stator Leakage Reactance (x1) 48
Stator Resistance (rs) 47
Status 13
Status Messages 11
Step Size 85
Step-by-step 22
Store Always 10-33 152
Store Data Values 10-31 152
Sw Id Control Card, 15-49 188
Sw Id Power Card, 15-50 188
Sw Version, 15-43 187
Switching Frequency 172
T
Term 32/33 Encoder Direction 111
Term. 29 Low Frequency 107
Term. 33 Low Frequency, 5-55 108
Terminal 33 High Frequency, 5-56 108
Terminal 33 Low Ref./feedb. Value, 5-57 108
Terminal 42 Output Min Scale, 6-51 118
Terminal 53 High Current 114
Terminal 53 High Voltage, 6-11 114
Terminal 53 Low Current 114
FC 300 Programming Guide Index
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark 233