Danfoss FC 300

Motor Protection 58
Motor Speed High Limit [hz], 4-14 87
Motor Speed Unit 28
Motor Thermal Protection 58
Motor Voltage 45, 191
N
Net Control 10-15 151
Net Reference 10-14 150
Normal Torque 44
Numerical Local Control Panel 23
O
Operating Hours, 15-00 181
Operating Mode 28
Operating State At Power-up (hand) 28
Operation Mode 176
Option Ident. 15-6* 188
Option Mounted, 15-60 188
Option Ordering No, 15-62 189
Option Serial No, 15-63 189
Option Sw Version, 15-61 189
Ordered Type Code String, 15-44 187
Output Filter, 14-55 180
Output Speed 55
Over Temps, 15-04 181
Over Volts, 15-05 181
Over-voltage Control 67
P
Parameter Access 151
Parameter Info, 15-9* 189
Parameter Selection 20
Parameter Set-up 17
Passive Load 54
Power Card Ordering No, 15-47 188
Power Card Serial No, 15-53 188
Power Hp, 16-11 191
Power Restore 85
Power Ups, 15-03 181
Precise Stop 58
Precise Stop Counter 196
Precise Stop Function 57
Pre-magnetizing 57
Preset Reference 72
Preset Reference Select, 8-56 134
Process Control, 9-28 139
Profibus Warning Word 140
Proportionalgain 122
Pulse Filter Time Constant #33, 5-59 108
Pulse Input 29, 16-67 195
Pulse Output Maximum Frequency #29, 5-65 110
Pulse Output Maximum Frequency #x30/6, 5-68 110
Pulse Reference 194
Pwm Random, 14-04 172
Q
Quick Menu 13, 17
Quick Menu Mode 13, 17
Quick Menu Password 41
Quick Stop Ramp Time 84
Quick Stop Select 132
Quick Transfer Of Parameter Settings Between Multiple Frequency Converters 14
Index FC 300 Programming Guide
232 MG.33.M2.02 - VLT
®
is a registered Danfoss trademark