Danfoss VLT AQUA FC 202 - Page 29

MyDrive® Select
MyDrive® Select performs drive sizing and dimensioning based on calculated motor load currents, ambient temperature, and cur-
rent limitations. Dimensioning results are available in graphical and numerical format and include calculation of eciency, power
losses, and inverter load currents. The resulting documentation is available as either .pdf or .xls format. The les can be imported to
MyDrive® Harmonics for evaluation of harmonic distortion or for validation of compliance with most recognized harmonic norms
and recommendations.
MyDrive® ecoSmart
™
MyDrive® ecoSmart
™
determines the energy eciency of the drive being used and system eciency class according to IEC 61800-9.
MyDrive® ecoSmart
™
uses information about the selected motor, load points, and an AC drive to calculate the eciency class and
part load eciency for a Danfoss drive, either for a standalone drive (CDM) or for a drive with a motor (PDS).
VLT® Motion Control Tool MCT 10
The MCT 10 software is designed for setup, commissioning and servicing of the AC drive. The tool includes guided programming of
smart logic control, cascade control, and condition-based monitoring. A separate manual is available for VLT® Motion Control Tool
MCT 10.
AJ300847815559en-000101 / 130R0337 | 29Danfoss A/S © 2020.09
Product Family Overview
VLT® AQUA Drive FC 202
Design Guide