Table of Contents
ii
Printing 3-1
Using the Control Panel 3-1
Starting or Stopping Printing 3-2
Starting Printing 3-2
Stopping and Viewing Printing 3-2
Resuming Printing 3-2
Resuming from a Paper-Out 3-2
Removing Printed Pages 3-3
Removing Single Sheets 3-3
Sleep Mode 3-4
Entering Sleep Mode 3-4
Leaving Sleep Mode 3-4
Using Special Mode 4-1
Special Mode Functions 4-1
Entering Special Mode 4-2
Set-Up Mode Function 4-3
How Set-Up Works 4-3
Entering the Set-Up Mode 4-4
Overview of the Set-Up Mode 4-5
Options with Pre-determined Values 4-7
Options with Undetermined Values 4-8
Points to Remember 4-10
Macro Options and Values 4-11
INSTALL Options and Values 4-16
Safe Panel 4-18
Recalling Factory Settings 4-18
Exiting and Saving 4-19
Using the Diagnostic Functions 4-20
Print Configuration Function 4-20
Printing Test Function 4-22
Hex Dump Mode 4-23
Printing Alignment Adjustment 4-24
Top Adjustment Function 4-26
Setting of The First Dot Position on The Left Side Function 4-28
Changing Menu Access Options 4-30
MENU ACCESS Option and Values 4-30
Setting Setup Mode to Default Value (Standard) 4-31
Setting Setup Mode to Default Value (6820 Mode) 4-31
Set-Up Mode Quick Reference 4-32
To Next Page
Loading...
