Using Special Mode
4-30
Changing Menu Access Options
You can restrict the access to the Set-Up functions to avoid accidentally changing the
Set-Up options.
MENU ACCESS Option and Values
•
Overprinted values are the factory settings.
1 To enter Menu Access mode:
a) Make sure that the tractors are loaded with continuous feed paper and that the pa-
per select lever is set backward.
b) Turn the printer off.
c) Turn the printer back on while simultaneously pressing the “LOAD/FF” + “PARK” +
“ALT” keys.
2 To change Menu Access Option and values:
a) Press the NEXT( LOAD/FF) key to move to next option;
b) Press the PREVIOUS( PARK) key to move to previous option;
c) Press the ALT-NEXT keys to select the Option or value and move down;
d) Press the ALT-PREVIOUS keys to select the Option or value and move up;
e) Press SETUP/EXIT key to save the value and move to SAVE&EXIT menu.
3 Exit the Menu Access mode:
Turn the printer off to exit the Menu Access mode.
MENU ACCESS
Options
Values Description
<MENU-ACCES> Specify the type of access to the Set-Up functions
from the control panel or from the <FUNCTIONS>
menu.
ALL FUNC All functions are accessible.
MACRO ONLY Only MACRO functions are accessible from the
<FUNCTIONS> menu.
NO ACCESS Set-Up mode is inaccessible.
SAFE PANEL READY, PARK and LOAD require the ALT key to be
used as a two key operation for these functions.
NOTE: You can return to the All Functions Accessi-
ble mode by turning the printer on while pressing
the ALT, PARK and LOAD keys at the same time.
The printer enters the Set-Up mode with this opera-
tion.
NOTE: Do not press any keys alone or in combination, except for pressing the LOAD,
PARK and ALT keys simultaneously, when turning the printer on, to avoid initi-
ating unexpected tests not permitted for the user.
To Next Page
Loading...
